Curb Inlet Filter

The SS 300 Curb Inlet Filter is made to prevent the migration of sediment into the storm drain system at curbs while allowing for stormwater flow to prevent hazardous ponding on streets and roadways.  The device has a durable high visibility green mesh casing for good visibility in roadways.  The center is filled with biodegradable pine straw allowing for filtration and water flow, resisting molding and compaction.  On each end there is a pocket to accommodate sand bags or stone creating weight to keep the filter in place.  The weighted ends also allow for the creation of a 3 – 9 inch weir for stormwater release as needed to prevent the accumulation of water in streets.  This device is flexible, light weight for shipping, hauling and installation, and contains no rubber or sharp wire that can be harmful to installers or enter stormwater drains as an environmental hazard.   It is 9 inches in diameter with a 5 foot pine straw filled center and weight pockets of 1 foot each for a total of 7 feet in length.  A single filter can be used for a 5 foot inlet but multiple devices are recommended for larger openings.  It is sold as a kit including the SS 300 curb inlet filter filled with pine straw, 2 sand bag inserts and zip ties (stone / sand not included).  Sourced and made in America.